SPI TruTops Interface Overview

The new SPI TruTops Bend Interface allows you to use the material and bending process information from TruTops Bend. You can read it directly into the material management database of the SPI SheetMetal solution, and use this data during the design with AutoCAD, Mechanical Desktop and Autodesk Inventor. The flat pattern development is calculated according to the algorhythms of the NC program TruTops Bend. That means: It can directly be exported to TruTops Bend.
  




Highlights

  • Transfer of material and bending process information including tool specific compensation factors and radii from TruTops Bend (ToPs 600)  to:
    AutoCAD
    Mechanical Desktop
    Inventor
  • Bending tools predefined in TruTops Bend (ToPs 600) can be used during the initial design phase
  • Access to production radii
  • Eliminates faulty and redundant input of technology data
  • Unfolding fully compatible with the calculation methods of TruTops Bend
  • Transfer process data for bending directly to TruTops Bend
  • Uses bending information (bend angle, radius, tool combination, bending technology) available in TruTops Bend (enhanced DXF-format)
  • Unfolding can be used directly for process simulation and NC-code programming

Screenshots



Many companies still generate NC-programs at the bending machine. This creates unnecessary machine down time that could otherwise be utilized producing additional parts. "Off-line" preparation of NC code in the planning department and the digital transfer of this information to the machine allow this "value-added" part production to take place.

With the SPI TruTops Bend Interface, another tool for the "Sheet Metal Process Chain" is available, supporting a close co-operation between the design, planning and production departments.
 
The new SPI TruTops Bend Interface allows you to use the material and bending process information from TruTops Bend - you can read it directly into the material management database of the
SPI - SHEETMETAL solution, and use this data during the design with AutoCAD, Mechanical Desktop and Autodesk Inventor.
 
It is now possible to use the same tools that have been defined in TruTops Bend (ToPs 600) during the initial design phase. Using this process the exact bending radii is guaranteed. The generated unfolding is fully compatible with the calculation methods of the NC program, ToPs 600, and delivers all necessary production data.
 

You can directly transfer the unfolding from SPI to TruTops Bend (ToPs 600)  without the need for rework. The required bending information provided in the DXF format will include angle, radius, bending tool combination, etc. This developed blank can then be used directly for simulation and NC-code programming..